LambdaCalculator Construction calculators
My calculations
Settings

Electronics

Voltage divider calculator with load

Compare unloaded and loaded divider voltage. Calculate branch currents and resistor powers for a DC resistive circuit.

Resistive divider circuit

Example values are editable assumptions. Use a decimal point or comma without thousands separators.

V
kΩ
kΩ

This DC model uses ideal resistors and a fixed input voltage. Use a suitable buffer or regulator when the application requires a controlled supply.

Calculated result

Your result will appear here

Enter the measurements, then calculate.

Calculated in this browser.

Define the resistor connections

Connect R1 from the input voltage to the output node and R2 from the output node to the reference node. A resistive load RL, when enabled, connects from the output to the same reference node, in parallel with R2. All resistance inputs must be positive; zero input voltage is valid.

The model assumes a fixed DC input and ideal resistors. It excludes capacitance, source impedance, component tolerances, temperature effects and active or time-varying loads.

Unloaded and loaded divider equations

With no load, Vout = Vin × R2 / (R1 + R2). With a resistive load, first find Req = R2 × RL / (R2 + RL), then Vout = Vin × Req / (R1 + Req).

Source current is (Vin − Vout) / R1. The branch currents are Vout / R2 and, when connected, Vout / RL. Their sum equals the source current. Dissipation is I² × R in each resistor; total source power is Vin × source current.

Example: a 12 V divider with a 10 kΩ load

Assume Vin = 12 V and R1 = R2 = 10 kΩ. With no load, the output is 6 V. Connecting RL = 10 kΩ makes the equivalent lower resistance 5 kΩ and the output falls to 4 V.

  • Source current: (12 − 4) / 10,000 = 0.8 mA.
  • R2 current and load current: each 4 / 10,000 = 0.4 mA.
  • R1 power: 6.4 mW; R2 and RL power: 1.6 mW each.
  • Total source power: 9.6 mW, equal to the sum of resistor powers.

Can a resistor divider power a load?

A changing load changes the effective resistance and the output voltage. This calculation describes a specified resistive load; it does not promise a regulated output. Check whether the application needs a buffer, regulator or another circuit, and assess component ratings separately.

Sources and scope

These sources support the circuit model. The numerical example is original and is not a component selection or regulatory assessment.